Seagate Backup Plus Hub 8tb Not Recognized

Seagate Backup Plus Hub 8 TB is an efficient hard drive that helps you protect your data and keep it organized. If a hard drive is not recognized by your computer, you have to think from various perspectives because the issue might be with your hard drive, computer, USB cable, etc.

This article gives you the best solutions to fix the “Seagate Backup Plus Hub 8TB not recognized” problem. Now, let us learn the solutions in detail.


  • Before you move ahead with the troubleshooting solutions, it is always recommended to check the basics. In most instances, the problem usually lies with the fundamentals.
  • First, check your USB cable. If it is damaged, try a different one. If you use a USB hub, remove it and check whether the problem is rectified.
  • Trying a different port and computer can help you fix this problem.
  • If none of these troubleshooting solutions fix the problem, proceed with the following methods.


If your Seagate hard drive letter is the same as other existing disks, your Backup Plus will not be recognized by your computer. In that case, you should change the drive letter of your Seagate Backup Plus.

  • Open the Run command box (Windows + R).
  • Type diskmgmt.msc and click OK.
  • When directed to the Disk Management section, locate your hard drive. Since your hard drive has the same drive letter as other disks, your Seagate will appear as New Simple Volume.
  • Right-click on New Simple Volume and select the Change Drive Letter and Paths option. Then assign a different drive letter to your hard drive and click OK to confirm.
  • Select the Change Drive Letter and Paths


In the Disk Management section, if your hard drive appears as RAW or Unallocated, it signifies that it requires formatting. Follow these instructions to format your Seagate Backup Plus hard drive. Remember, your data will be completely erased when you format your hard drive.

  • Connect your hard drive to your computer.
  • Open the Disk Management section. Right-click on RAW/Unallocated and select the Format option.
  • In the Volume label field, give a name for your hard drive. Choose the File system as NTFS or exFAT.
  • Choose The File System

Note: To use your hard drive on both Windows and Mac computers, choose the file system as exFAT. If you are going to use it only on your Windows computers, select NTFS.

  • Leave the Allocation unit size as Default, check the Perform a quick format box, and click OK.
  • Within a few seconds, your Seagate Backup Plus drive will be formatted.
  • Now, ensure your computer recognizes your hard drive.

We hope these troubleshooting solutions help you fix the “Seagate Backup Plus Hub 8TB not recognized” problem. If you still cannot solve this issue, you can reach our technical experts for assistance.

Call Us
Copyright © 2023 - 2024 External Hard Drive Setup | All rights are reserved.