HDD Not Detected In Bios On Windows 10

Configuring a hard drive’s settings in BIOS is pretty easy. But an issue might pop up when your BIOS fails to detect the attached drive. There are a host of factors for this problem to occur. So, it is somewhat hard to figure out why your HDD not detected in BIOS.

External Hard Drive Not Detected In Bios

Fortunately, there are some simple and quick troubleshooting solutions that can help you resolve this problem.

The remaining part of this page covers why your ATA/SATA HDD is not detected in Windows 10 BIOS and how to resolve it.

Hard Drive Not Showing Up In BIOS - Windows 10 - Causes

In most cases, the BIOS of your computer fails to detect the attached hard drive if:

  • You have installed an incompatible drive.
  • The connection is incorrect.
  • A damaged cable is used for connecting.
  • There is a problem with the drive.
  • The drive settings are misconfigured.
  • CSM (or Compatibility Support Module) is disabled in the BIOS (If you’re using an Asus laptop, you need to enable this option in BIOS to view and access the attached hard drives).

Hard Drive Not Showing Up In BIOS Windows 10- Let’s Fix It

Some proven workarounds that you can try to resolve this HDD issue are discussed below. Perform each method one by one. After performing each method, check if the drive is detected. If your attached HDD is not detected in the BIOS of your Windows 10 computer again, try the next method.

Check The Cable And Its Status

  • In most cases, using a faulty or damaged cable can lead to these kinds of drive problems. Therefore, make sure that the cable you have connected is not a damaged one.
  • Next, check if the cable is securely connected to the right port. If not, unplug and reconnect the cable.

Enable CSM

The instructions below refer to the Asus motherboard.

  • Check if the CSM setting is disabled in BIOS. If yes, enable it.
  • To do so, open the BIOS Utility on your computer.
  • Now, switch to Advanced Mode by pressing the F7 key.
  • Go to Boot >> CSM.
  • Now, choose the Enabled option from the drop-down menu beside Launch CSM.
  • Click OK.

Load The Default BIOS Settings

  • Open the Exit tab in the BIOS window of your Windows 10 computer.
  • Select the Load Default Settings option using the arrow buttons.
  • Tap Enter to confirm the action.
  • Once the default settings are loaded, exit from the window by pressing the F10 key.

Change The Faulty Or Incompatible Hard Drive

  • Make sure that you’re not using a faulty hard drive.
  • Check if the hard drive you have installed is compatible with your desktop or laptop’s motherboard.
  • If not, change the drive and check whether the new HDD is detected in BIOS.

Is your HDD not detected in BIOS again? Then, contact us by making use of the call option. To know about how to fix Seagate Barracuda Not Showing Up In BIOS issue, then click here.

Call Us
Call Us
Copyright © 2023 - 2024 External Hard Drive Setup | All rights are reserved.